P
RO
V
U
PD6210 Analog Input Batch Controller Instruction Manual
40
Grand Total Reset Password & Non-Resettable Total
The grand total can be password-protected to prevent unauthorized total resets.
The grand total can be programmed as a non-resettable total by entering the password “050873”.
Caution!
Once the Grand Total has been programmed as
“non-resettable” the feature
cannot
be disabled.
Making Changes to a Password Protected Controller
If the controller is password protected, the controller will display the message
Locd
(
Locked
) when the
Menu button is pressed. Press the Enter button while the message is being displayed and enter the
correct password to gain access the menu. After exiting the programming mode, the controller returns to
its password protected condition.
Disabling Password Protection
To disable the password protection, access the
Password
menu and enter the correct password twice, as
shown below. The controller is now unprotected until a new password is entered.
If the correct six-digit password is entered, the controller displays the message
unLoc
(unlocked) and the
protection is disabled until a new password is programmed.
If the password entered is incorrect, the controller displays the message
Locd
(Locked) for about two
seconds, and then it returns to Run Mode. To try again, press Enter while the
Locked
message is
displayed.
Did you forget the password?
The password may be disabled by entering a master
password once. If you are authorized to make changes,
enter the master password 508655 to unlock the
controller.
!
