12
13
7 Step:
Return the rail to the wall and just place the screws to support it (7°Step
will only be done if it is fixed in masonry).
8 Step:
Place the rail well leveled and tighten the screws to secure it permanently.
Note:
We suggest that the leveling be done with laser level.
GLASS INSTALLATION
10 Step:
Fit M6 nuts in the housing of the right/left flange
for fixing the movable glass.
Note:
For all parts that are fixed to the flange,
M6 x 10mm screws with 6mm flat washer must
be used, otherwise there is a risk of breaking the
glass.
11 Step:
Mount the flanges and pulleys on the
movable glass.
Fit part 1 in the hole of the movable glass, one on each side, then place part 2
in the hole of part 1 and tighten with part 9. Fit parts 3 and 4 in the holes of the
movable glass, fit part 2 in the hole in part 3, place part 5 on the opposite side of
parts 3 and 4 by fitting the holes in part 4. Note that the holes that fit in part 4 are
at the bottom of part 5.
Tighten parts 4 and 5 with parts 6, 7, and 8 and tighten parts 2 and 5 with part 9.
See the example in figure 10 and the parts table.
12 Step:
Fit the movable sheet (with the pulleys) onto the rail. Fit the nylon guide to
the movable glass, leaving it aligned with the fixed glass. Erect the movable glass
and fix the nylon guide by screwing it to the ground.
13 Step:
Glue the PS glass stop rubber to the sides, along its entire length, where
the movable sheets meet.
Note: To glue the rubber profile, it is necessary to clean it with alcohol, thinner or
clean water in the place indicated for gluing.
14 Step:
Place one sheet against the other and check for misalignment. Make
the adjustment by moving the eccentric shaft of the pulleys until the sheets are
aligned. For this, use a 6mm allen wrench and a 22mm open-end wrench.
After alignment, tighten the nuts definitively.
Note:
Perform this procedure on both leaves.
Attach nylon guides to the ground.
PS turn stop
rubber
6mm allen wrench
22mm spanner
