6
7
INSTALLATION AND FIXATION OF THE OPERATOR
Before installing the operator, check if the structure is aligned and in
good condition for a better functioning of the automation. Also check if
the electrical network is specific for the automation.
PARAMETER AND TECHNICAL CHARACTERISTICS
OPERATOR TYPE
SLIDING
SLIDING
SLIDING
RATED VOLTAGE
220 V
220 V
127 V
NOMINAL FREQUENCY
60 Hz
50 Hz
60 Hz
RATED POWER
70 W
70 W
80 W
ENGINE ROTATION
2610 rpm
2610 rpm
2610 rpm
NOMINAL CHAIN
0,7 A
0,7 A
1,4 A
REDUCTION
2:20
2:20
2:20
LINEAR SPEED
30 m/min
30 m/min
30 m/min
MANEUVERS
180 cycles/h
180 cycles/h
180 cycles/h
DEGREE OF PROTECTION
IPX 0
IPX 0
IPX 0
MAXIMUM LOAD
1 leaf of 90 kg or
2 leaf of 150 kg
(75 kg each)
1 leaf of 90 kg or
2 leaf of 150 kg
(75 kg each)
1 leaf of 90 kg or
2 leaf of 150 kg
(75 kg each)
TEMPERATURE RANGE
-5°C
+50 °C
-5°C
+50 °C
-5°C
+50 °C
ISOLATION TYPE
Class B, 130°C
Class B, 130°C
Class B, 130°C
TECHNICAL CHARACTERISTICS
PROCEDURE BEFORE INSTALLATION
Identify at the place of installation, what is your case for the installation of the Tore
operator in one of the steps below:
1 Step:
The height of the Tore set will occupy the space corresponding to 150
mm in height at the fixing location (figure 1). It can only be implemented if the site
is in good condition and the wall is not warped, otherwise provide the necessary
repairs.
2 Step:
The Tore operator will be installed in a gap (directly on the ceiling): If it is
directly on the ceiling (span), it will not need a structure (figure 2).
3 Step:
Installing the Tore operator in a corridor span: in the installation inside the
span, it is necessary that the structure support the weight of the operator and also
the glass, in case it realizes that it will not support ask to reinforce the structure.
RIGHT FOOT
105
142
WALL
PICTURE 1
RIGHT FOOT
105
142
SLAB
PICTURE 2
