19
PROGRAMMING PGM OUTPUT (LOCK)
Figure 16 – PGM mode selection screen
Figure 16 – Settings screen of how the Agility TRV board output will behave as a programmable PGM output.
Retention Mode
The PGM output will be retained in the on state when a sector is violated and will remain in this state even if
the board is turned off and on.
The PGM output will leave the on state when the board receives a valid transmitter command to open the
gate.
When the PGM output is in hold mode only the garage light will be used to inform the user that the alarm
has been armed / disarmed.
Pulsed Mode
When a sector is violated, the PGM output will enter a continuous pulsating state until the user-programmed
siren time expires.
The pulse time is 10 seconds on and 10 seconds off and then this process is repeated continuously until the
siren time expires.
After the siren time expires or a valid transmitter command is received, the PGM output will be turned off and
the board will enter the sector monitoring mode for alarm if the gate is closed.
G
D
R
M
E
V
M O
T
P
C
a
x
o
x
c
x
n
x
t
x
t
x
:
x
PGM operating mode - TRV output
Retention
1 pulse
3 pulse
Siren
Pulsed
2 pulse
Command pulse receiver
Monitor sector with the
gate closed
Monitor sector with
the gate closed
PGM output
Violated Sector
Timing Siren
Siren Time= 0
or
Transmitter Command
Monitor sector with
the gate closed
PGM output
Violated Sector
Retained
Transmitter command
Monitor sector with
the gate closed
10sec
10sec
10sec
