6
• Remove the recovery water tank (Fig 2).
Fig 2
• Connect the battery connectors (Fig 3 & 4).
Fig 3
Fig 4
• Replace the recovery water tank and screw into place.
WARNING
Make sure that the building power supply is
equipped with GFI (circuit breaker).
2.2 Charging the batteries
WARNING
Charge batteries in a well ventilated
area which complies with local, state and federal
regulations and with standards in force in the
country of use.
• Move the machine close to a electrical socket.
• Unwind the battery charging lead at the rear of the
machine and connect to the outlet.
WARNING
Check that the building power supply
matches the operating voltage of the battery
charger (100 – 120V, 50/60Hz).
• Let the batteries charge until the “Green” LED comes
on, then remove the plug and wind the battery charging
around the cable holder (Fig 5).
Fig 5
NOTE:
10 hours are required for complete battery
charge.
• IMPORTANT - Overcharging will damage the batteries.
This will cause run time to be reduced and overall bat
tery life will be affected. AVOID OVER CHARGING.
2.3 Adjusting the handle height
Select the most comfortable handle height using the
adjustment lever (#6 on Fig 10) on the handle. Release
the lever and lock in position.
2.4 Attaching the brushes and pads
WARNING – This appliance has been designed
for use with quality brushes and pads only.
The use of inappropriate brushes and pads
may affect its performance and safety.
WARNING
Be sure the machine is switched off
before adding or changing accessories.
• The solution tank and recovery tank must be empty
prior to changing brushes/pads.
• Ensure handle is in upright position and the squeegee
is in the up position.
• Carefully lift the front of the machine to expose the
clutch plate (Fig 6).
Fig 6
• Attach the brush/drive disc onto the clutch plate and
rotate the brush/drive disc until secure (Fig 7).
• Return the machine in the upright position.
