10
5.2 Draining and cleaning the recovery tank
At the end of the cleaning cycle or when the recovery
tank is full, it is necessary to empty the tank by
proceeding as follows:
• IMPORTANT
– To dispose of the solution in the
recovery tank, comply with the local, state, and federal
standards in force in the country in which the machine
is being used.
• Position the machine near a drain outlet.
• Disconnect the drain hose from the support on the
back of the machine.
• Remove the cap from the hose and drain all water
from the tank (Fig 18).
Fig 18
WARNING!
After each use, it is necessary to clean the
recovery tank to prevent deposits or scaling and the
growth of bacteria, odors or mold.
• Remove the cover, and clean the inside of the cover
and the vacuum safety float with running water.
• Leaving the hose lowered and the cap off, run water
though the upper opening, cleaning the inside of the
tank until clean water comes out of the drain hose.
• Replace all components in reverse order.
5.3 Draining and cleaning the solution tank
WARNING!
– After each use, it is necessary to drain
and clean the solution tank to prevent deposits or
scaling.
• Position the machine over a drain outlet.
• Turn the drain connector outwards (Fig 19).
Fig 19
• Push the hose clip (1) inwards while removing the cap,
letting all the water drain out.
• Wash the inside of the tank, leaving the drain cap open
and adding clean water though the front opening.
• After cleaning, replace the cap, pushing inwards.
•
IMPORTANT
– To dispose of unused cleaning
solution, comply with the local, state, and federal
standards in force in the country in which the machine
is being used.
5.4 Cleaning the squeegee blades
To clean the squeegee correctly it is necessary to
remove it as follows (Fig 20):
Fig 20
• Pull the squeegee unit (1) outwards.
• Disconnect the hose (2) from the squeegee (1).
• Loosen the knobs (3) and remove the squeegee (1)
Fig 21
• Wash the squeegee unit, and specifically the rubber
blades (1) and the inside of the vacuum hose
connector (2). (Fig 21)
If the rubber blades are damaged or worn, it is
necessary to replace them or turn them over.
6. Storage
• Always switch off, empty, wipe down and dry the
machine after use.
• The solution tank and recovery tank must be
emptied and flushed out with clean water.
• Wrap the battery charger cord around the cable
winder, ensuring that the plug is not trailing on the
floor.
1
