PowerStroke PS80903A, Руководство оператора

Страница: 8 / 48

Page 8 — English
ASSEMBLy
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-connect Nozzles (4)
Injection Hose
Injection Hose Filter
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Rear foot assembly (2)
Lock nuts (4)
Hex head bolts (2)
Axle
Hitch pins (4)
Wheels (2)
Handle
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING FEET ON THE FRAME SUPPORT
See Figure 2.
Locate the following items:
Rear foot assembly (2)
Lock nuts (4)
Hex head bolts (4)
 Raise the rear end of the pressure washer high enough to
gain access to the frame bottom; securely position props
underneath to support.
To attach a leg to the frame support:


Position a leg piece over the holes on each side of the
frame support.

Insert a hex head bolt through each of the two holes in
the frame and the leg piece.
  Secure the bolts by installing a self locking nut over each
bolt end on the inside of the frame. Tighten the nut se-
curely.

 Repeat with remaining leg.
ATTACHING THE WHEEL ASSEMBLy
See Figure 3.

Locate the axle, hitch pins, washers, and wheels. Remove
the hitch pin from the axle.

Slide the axle through the hole in the center of the
wheel.

Slide the washer onto the axle.

Lift the machine and slide the axle into the wheel mount-
ing hole in the machine base as shown.

Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.

Repeat with the second wheel.
INFLATING THE TIRES
WARNING:
To reduce the risk of injury, do not over-inflate the tires
of this unit. During inflation regularly check the pressure
using a reliable tire pressure gauge, and never exceed
25 psi. Always ensure the bolts in the wheel hubs are
securely tight before adding pressure to the tire.
NOTE: The tire should be inflated only using a hand
pump.
INSTALLING THE HANDLE
See Figure 4.
To install the handle:

Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the
handle in place.
ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the injection
hose must be attached.
 Push the open end of the clear injection hose securely
over the fitting as shown in figure 3.

Place the filtered end of the injection hose in the bottle
of detergent.