powersoft D-Cell504 IS, Руководство пользователя

Страница: 29 / 39

powersoft_dcell504_uguide_en_v4.0 www.powersoft-audio.com
29
D-Cell504
User Guide
1 GND
2 –12VDC Auxiliary Voltage
3 DSPOUTCH4 Ch 4 DSP output
4 IN2-
5 IN2+
6 GND
7 BY OUT2
8 BY IN2
9 PRTOUT2** Ch 1 Output protection flag , HIGH = protection active see Section 0, points 4) and 5)
10 MUTE Mute Command (pull to GND to mute the outputs)
11 TEMPOUT Temperature Protection flag, see Section 0 point 6)
12 PRSTLED1 Preset 1 Selection Led
13 PRSTLED2 Preset 2 Selection Led
14 PRSTLED3 Preset 3 Selection Led
15 PRSTLED3 Preset 4 Selection Led
16 READYOUT ready status output (led drive) and fast output shut downs
17 PRSTSELECT Push button for preset scroll selection, pull to GND to scroll.
18 PRTOUT1** Ch 1 Output protection flag , HIGH = protection active see Section 0, points 4) and 5)
19 BY IN1
20 BY OUT1
21 GND
22 IN1+
23 IN1-
24 DSPOUTCH3 Ch 3 DSP output
25 +12VDC Auxiliary Voltage
26 GND
CN2: Pins description
PIN Description Notes
1 GND
2 IOUT1MONITOR* Limiter detector output signal (channel 1): high when one of the limiting protections is active (see Section 0)
3 ZLOAD1 Load impedance analog output signal
4 EARECT1 Rectified error amplifier output Channel 1, see Section 4.1
5 Reserved TO NOT BE USED
6 Reserved TO NOT BE USED
7 Reserved TO NOT BE USED
8 Reserved TO NOT BE USED
9 Reserved TO NOT BE USED
10 Reserved TO NOT BE USED
11 TEMP Analog temperature monitor output (see Section 0) - Connected to CN1000-pin11 on the Interface Board
12 Reserved TO NOT BE USED
13 Reserved TO NOT BE USED
14 Reserved TO NOT BE USED
15 Reserved TO NOT BE USED
16 +5VDC see…………..
17 EARECT2 Rectified error amplifier output Channel 2, see Section 4.1
18 ZLOAD2 Load impedance analog output signal
19 IOUT2MONITOR* Limiter detector output signal (channel 2): high when one of the limiting protections is active (see Section 0)
20 GND
CN3: Pins description
PIN Description Notes
1 +VCC
2 +VCC
3 +VCC