powersoft D-Cell504 IS, Руководство пользователя

Страница: 21 / 39

powersoft_dcell504_uguide_en_v4.0 www.powersoft-audio.com
21
D-Cell504
User Guide
DSP Programming Setup
What you need to program your D-Cell504DSP :
- DCELLPROG11 Programming Board
- USB cable (for the communication between PC and DCELLPROG11 Programming Board)
- 16 poles Flat Cable (for connection between DCELLPROG11 Programming Board and D-Cell504DSP or D-
CELL504DSP-IS)
- D-CELL504DSP or D-CELL504DSP-IS
Powering up the board.
The DCELLPROG11 Programming Board is powered via the 16 poles Flat Cable by the D-Cell itself.
- Connect the amplifer and the Programming Board as indicated in the following picture if you’re using an IS
version or to connector CN2 of the output stage unit if you’re using the version without chassis, and turn on the
D-Cell504.
- The POWER LED should be lit.
Connecting the board to the computer
1) Use the included USB cable to make a connection between the evaluation board and an available USB port on your
computer.
2) Windows should recognize the device, and Found New Hardware Wizard should display.
3) Select "Install from a list or specific location (Advanced)" and then "Search for the best driver in these locations." Ensure
that "Search removable media" is unchecked and "Include this location in the search" is checked.
4) Browse to find the USB drivers folder. (By default, it should be at C:\Program Files\Analog Devices Inc\Sigma Studio\USB
Drivers.) Click OK and Next to begin the installation. (Click Continue Anyway if you're prompted with "the software hasn’t
passed Windows Logo testing.") Click Finish when done.
POWER LED
COMMUNICATION LED
RESET BUTTON
NOTE: During the programming operations, in the start up phase and more in general when DSP and the
programmer communicate, the COM LED will be on for a very short time. When the COM LED is steady on, it
indicates that the in/out communication is not correctly working. In this case, press the RESET BUTTON to
ripristinate the communication.