33
Brake
The
Admiral 4
0
is equipped with
a service brake and a parking brake.
The drum brake on the rear wheels is
hydraulic (service brake) and mechani-
cal for the parking brake (control ca-
bles). Adjust hydraulic service brake
with screw in the rear of the anchor
plate; the parking brake uses threaded
ends on the control cables. Brake fluid
reservoir is located in the pedal area
under the tunnel fairing.
Fill level in reservoir:
3
/
4
.
Quantity: 0.08 Us gal (0.3 litres) of
ATE brake fluid.
Change brake fluid every two years.
The driver must not leave the machine
unless having stopped all motors, se-
cured the machine against unintended
movement, locked the parking brake
and pulled the key.
Wheelchange
To change rear wheels, jack the
Admiral 4
0
on either side, as re-
quired. Put 2-ton hydraulic jack under
lifting pads attached to frame in front of
the rear wheels.
For changing the front wheel, put jack
under forward frame brace (center).
Torque wheel attaching nuts to 140 Nm.
Check wheel attaching nuts for correct
torque after first 100 hours and there-
after every 200 hours.
Travel drive assembly
Travel drive assembly uses a geared
motor on the steerable front wheel.
Traveling speed uses continuous con-
trol by the accelerator pedal (electronic
pulse control). Transmission uses con-
ventional gears in an oil bath.
Oil fill: 0.68 US gal (2.6 litres) of SAE
80-90 transmission oil.
Oilchange: after first 200 hours in
service, thereafter every 2000 hours,
but not less than once a year.
Drain plug is located at the bottom of
the transmission (Allen plug). Filler
neck (may be used to check oil level
either) is located on top of the trans-
mission (forward end).
81
Brake
The Hakomatic 1100 is equipped with
a service brake and a parking brake.
The drum brake on the rear wheels is
hydraulic (service brake) and mechani-
cal for the parking brake (control ca-
bles). Adjust hydraulic service brake
with screw in the rear of the anchor
plate; the parking brake uses threaded
ends on the control cables. Brake fluid
reservoir is located in the pedal area
under the tunnel fairing.
Fill level in reservoir:
3
/
4
.
Quantity: 0.08 Us gal (0.3 litres) of
ATE brake fluid.
Change brake fluid every two years.
The driver must not leave the machine
unless having stopped all motors, se-
cured the machine against unintended
movement, locked the parking brake
and pulled the key.
Wheelchange
To change rear wheels, jack the
Hakomatic 1100 on either side, as re-
quired. Put 2-ton hydraulic jack under
lifting pads attached to frame in front of
the rear wheels.
For changing the front wheel, put jack
under forward frame brace (center).
Torque wheel attaching nuts to 140 Nm.
Check wheel attaching nuts for correct
torque after first 100 hours and there-
after every 200 hours.
Travel drive assembly
Travel drive assembly uses a geared
motor on the steerable front wheel.
Traveling speed uses continuous con-
trol by the accelerator pedal (electronic
pulse control). Transmission uses con-
ventional gears in an oil bath.
Oil fill: 0.68 US gal (2.6 litres) of SAE
80-90 transmission oil.
Oilchange: after first 200 hours in
service, thereafter every 2000 hours,
but not less than once a year.
Drain plug is located at the bottom of
the transmission (Allen plug). Filler
neck (may be used to check oil level
either) is located on top of the trans-
mission (forward end).
