Power Fist 8957425, Руководство пользователя

Страница: 7 / 36

V4.0 120V 1,000 BPM Demolition Hammer Kit 8957425
Visit www.princessauto.com for more information 7
the National Electrical Code. (See Figure B.)
• Double insulated tools may be used in either of the 120 volt outlets shown
in the following illustration.
EXTENSION CORDS
• Use a proper extension cord. Make sure your extension cord is in good
condition. When using an extension cord, be sure to use one heavy enough
to carry the current your product will draw. An undersized cord will cause a
drop in line voltage, resulting in loss of power and cause overheating.
•
Be sure your extension cord is properly wired and in good condition.
Always replace a damaged extension cord or have it repaired by a qualified
person before using it. Protect your extension cords from sharp objects,
excessive heat and damp or wet areas.
• Grounded tools require a 3-wire extension cord. Double Insulated tools can
use either a 2- or 3-wire extension cord.
•
As the distance from the supply outlet increases, you must use a heavier
gauge extension cord. Using extension cords with inadequately sized wire
causes a serious drop in voltage, resulting in loss of power and possible
tool damage.
• The smaller the wire’s gauge number, the greater the capacity of the cord.
For example, a 14-gauge cord can carry a higher current than a 16-gauge
cord. Minimum extension cord wire size is shown in the following table:
MINIMUM WIRE SIZE OF EXTENSION CORDS
Nameplate AMPS Cord Length
25' 50' 100' 150'
0-6 18 AWG 16 AWG 16 AWG 14 AWG
6-10 18 AWG 16 AWG 14 AWG 12 AWG
10-12 16 AWG 16 AWG 14 AWG 12 AWG
12-16 14 AWG 12 AWG Not Recommended
• When using more than one extension cord to make up the total length,
make sure each cord contains at least the minimum wire size required.
• If you are using one extension cord for more than one tool, add the
nameplate amperes and use the sum to determine the required minimum