3/4 HP Shallow Well Jet Pump
5
Visit www.princessauto.com for more information
8458788
V 3.0
PARTS IDENTIFICATION
WARNING! Do not operate the tool if any part is missing. Replace the missing part before operating. Failure to
do so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make sure that all items in the parts
list are included.
Contents:
• Shallow Well Jet Pump
A 1-1/4 in. NPT Suction Port
B 1 in. NPT Discharge Port
C Junction Box
D Drain Plug
E 1/2 in. Priming Port
F Pressure Switch
ASSEMBLY
When this manual refers to a part number, it refers to the included Parts List section.
PRE-INSTALLATION
The following materials may be required to install the pump.
• PVC cement (if plastic pipe is used)
• Thread tape
• Pipe, pipe couplings and fittings
• 1 in. nipple (for discharge)
• 1 in. tee or 90° elbow (for discharge)
• 1 in. pipe plug if tee is used
• 1-1/4 in. foot valve (for cased wells)
• Single pipe well seal for 1-1/4 in. pipe (cased or dug wells)
• Copper electrical wire (See Wiring Instructions)
INSTALLATION
WIRING INSTRUCTIONS
WARNING! Meet national electrical code and local codes for all wiring. Improper wiring may lead to a fatal
electric shock. A licenced electrician should perform all wiring involved with this pump.
Installation requires wiring components into the pump. Ground the motor before connecting it to an electrical power
source to avoid an electric shock. Do not use a gas supply line to ground the pump.
Make certain that the power supply conforms to the electrical specifications of the motor supplied. Supply voltage
must be within 10% of nameplate voltage (see Specifications). Incorrect voltage can cause a fire or seriously
damage motor.
The user may wish to create a permanent connection between the pump and power source. Do not use an extension
cord or attempt to splice wires for a permanent connection. A certified junction box is a safer choice.
To reduce the risk of electric shock, install motor and all electrical components above the top grade level of the
sump. This pump is not submersible.
