Multi-Purpose Oscillating Tool
15
For technical questions call: 1-800-665-8685
8383853
V 2.0
Fig.7
6. Continue to make several plunge cuts until the bottom of the
door jamb and casing are completely cut off and the loose pieces can
be easily removed.
Follow the same basic procedure for installing carpet, using a thicker
spacer that is the samethickness of the carpet being installed.
CUTTING A HOLE IN WOOD FLOORING
TO INSTALL A HEATING VENT
The multi-function power tool can be used
to cut a hole in wood flooring for installing a
heating vent.
1. Install the plunge cutting saw blade for
wood in the tool
(Fig. 2 Page 13).
NOTE:
The blade should be centered
on the tool housing and NOT installed in
the 90° position
2. Place the floor vent on the floor and
use a soft lead pencil to trace the
required rectangular hole (1) on the flooring (Fig. 7).
3. Place the saw blade (2) near the floor surface in the middle of one of
the cutting lines.
4. Turn the tool ON (Fig. 5).
NOTE:
The tool and blade should be at a 45° angle to the floor to allow
the corner of the blade to plunge cut into the flooring.
5. While holding the tool tightly, slowly plunge the corner
of the blade into the flooring until it cuts through the flooring.
Once the plunge cut is complete, set the tool to its highest
speed and complete the cut to the corner of the rectangle.
6. Turn the saw OFF, remove it from the cut and proceed to cut in the
opposite direction to complete the cut for the first side of the rectangle.
7. Repeat steps #4, #5 & #6 to cut the remaining three sides
of the rectangle.
