Multi-Purpose Oscillating Tool
12
For technical questions call: 1-800-665-8685
8383853
V 2.0
INSTALLING ACCESSORIES
All accessories are installed on the multi-function power tool in a similar
manner. For the purposes of describing the accessory installation, the half
circle blade is used.
WARNING! Always remove the plug from the power source before installing
or removing accessories or sandpaper. Failing to remove the plug from the
power source may result in the tool accidentally being started and causing
serious injury to the operator.
1. Remove the screw (1)and washer (2)
from the accessory holder (3) by turning
the screw counter clockwise. Use the
5 mm Hex key (4) if the screw is too
tight to be removed by hand (Fig. 1).
2. Place the blade (5) on the accessory
holder (Fig. 2).
NOTES:
a) Make sure the alignment holes (6)in
the blade fit over the alignment pins (7)
in the accessory holder and the printed
side of the blade is facing the tool.
b) The blade can be mounted at various
angles left or right of center if required.
3. Thread the screw (1) through the
washer (2) and the blade and into the
accessory holder threaded hole (8).
4. Turn the screw clockwise until it is finger tight.
NOTES
:
a) Check to make sure the convex curve of the washer is facing the
head of the screw and the slots in the edge of the washer fit over the
alignment pins in the accessory holder.
Fig. 1
Fig. 2
