Multi-Purpose Oscillating Tool
14
For technical questions call: 1-800-665-8685
8383853
V 2.0
Verify the following every time the multi-function power tool is used:
1. Safety glasses, safety goggles, or face shield are being worn.
2. Hearing protection is being worn.
3. The blade or sandpaper is in good condition.
4. The accessory is properly tightened onto the accessory holder
of the tool.
Failure to observe these safety rules will significantly increase the
risk of injury.
FLUSH CUTTING A DOOR JAMB AND CASING
FOR INSTALLING FLOORING
The multi-function power tool can be used
to flush cut a door jamb and casing to allow
space for the new flooring to fit neatly under
the door jamb and casing. For the purpose
of demonstrating the procedure, floor tile is
being used.
1. Install the plunge cutting wood saw
blade for wood in the tool (Fig. 2).
NOTE:
The blade should be centered on
the tool housing and NOT installed in
the 90° position.
2. Place a scrap piece of floor tile (1) on the floor about 1/2” (25 mm)
from the door jamb (2) (Fig. 6).
NOTE:
Make sure the “good” side of the tile is facing upward to provide a
smooth surface for the blade to follow.
3. Place the tool with the saw blade (3)lightly touching the surface of the
tile and the cutting teeth NOT touching the surface to be cut.
4. Turn the tool ON (Fig. 5 Page 14).
5. When the tool reaches its maximum set speed, carefully plunge the
blade into the door jamb (4) while sliding the blade along the floor tile.
NOTE:
Hold the tool tightly and do not put too much forward pressure on
the saw blade when cutting, as this will cause the tool to
vibrate excessively.
Fig.6
