Page 17
Hardware DIP Switch Position Behavior Table
Switch
position
ON
OFF
1
Download MCU – RX
Download MCU – ARM
(Default)
2
WiFi interface
(Default)
LAN interface
3
Paper cutting after cover return –
disable
paper cutting after cover return –
enable
(Default)
4
Full paper cutting enable
Full paper cutting disable
(Default)
5
Busy condition disable
Busy condition enable
(Default)
6
Cutting without paper feed before
paper cutting
Normal cutting before paper
cutting
(Default)
7
Auto cutter disable
Auto cutter enable
(Default)
8
Firmware update mode enable
Firmware update mode disable
(Default)
Switch position 8 defines the firmware update mode. If the printer needs
to update the firmware, please set the switch position 8 to the “ON”
position. In order to operate perfectly, set the switch position 8 to “OFF”
when the printer does not need to update the firmware or operates in
normal condition.
Setup
through
software
switch
:
Another method of setting up PP-6906 series is implemented through the
software switch setting, which means that software utility must be used for
setup of other functions. Please visit our web site
http://www.posiflex.com/up/Download/downlaod
to download the
PP-
6906 software switch utility.
Software switches are divided into
SW1,
SW2
,
SW3 and SW4
. These settings are described below.
After downloading the
PP-6906 software switch utility
, refer to the Help
file in the utility folder for the details before operating the software switch
setup.
Position Behavior Table for Software Switch 2
Switch
position
ON
OFF (Default)
Software Switch Selection
1
Enable software switch setup
1
Enable hardware DIP switch setup
2
Paper width – 58mm
Paper width – 80mm
