Page 18
Switch
position
ON
OFF (Default)
3
Print width allowable – 576 dots
Print width allowable – 512 dots
4
Paper feed back disable
Paper feed back enable
5
Raster bitmap printing – line print
Raster bitmap printing – batch
print
6
Parity check – EVEN
Parity check – NONE
7
Handshaking – XON/XOFF
Handshaking – DTR/DSR
8
<CR> Auto line feed enable
<CR> Auto line feed disable
Note: 1. Software switch setup will be valid instead of hardware DIP
switch setup.
Position Behavior Table for Software Switch 3
Switch
position
ON
OFF
1
UPOS write disable
UPOS write disable
(Default)
2
Beep sound after paper cutting –
enable
Beep sound after paper cutting –
disable
(Default)
3
4
5
Print density switch
(
Refer to the setting guide made below for the details.
)
6
Print speed – 200mm/s
Print speed – 170mm/s
(Default)
7
Thai font mode – 3 pass
Thai font mode – 1 pass
(Default)
8
Cover open message enable
Cover open message disable
(Default)
Effect of switch positions 3, 4, and 5 on Print Density is defined below:
SW3 Pos.3
OFF
ON OFF ON
SW3 Pos.4
OFF
OFF ON ON
SW3 Pos.5
OFF
OFF OFF OFF
Print Density (%)
100
(Default)
110 120 130
Since papers are different in quality, please regulate the print density and
printing speed to obtain the satisfaction of printing quality.
Position Behavior Table for Software Switch 4
Switch
position
ON
OFF
1
Print speed of 120mm/s – enable
Print speed of 120mm/s – disable
(Default)
2
Reduction of barcode height
