Page 9
SPECIAL ADJUSTMENT OF PAPER ROLL SENSOR
Near-End Sensor for Paper Roll
The near-end sensor for paper roll in the printer is able to have the printer work
with a paper roll of several bobbin sizes. Please refer to the figure shown
above for the paper roll compartment in which there are a plastic thumb wheel
for bobbin-size adjustment, and a sensor block on the wall. Turn the thumb
wheel to adjust the proper position of sensor block. When the printer is placed
on a flat desk and the paper roll in the compartment is exhausted, the near-end
sensor block ejects and stays above the bobbin of paper roll and thus stays
active, as shown below.
.
Accordingly, when the printer is placed horizontally instead of being hanged
vertically on the wall, the printer’s near-end sensor block functions and the
sensor position adjust can be used by users for the activity of sensor block.
The outer diameter of paper roll bobbin is between 18 and 24 mm, which is
acceptable.
Spacer
Plate Installation for Paper Roll of 58mm Width
The application of 58mm-width paper roll in this printer can be achieved
through adoption of a spacer plate and an internal DIP switch setting. For more
detailed setting guide, please refer to the last topic of this manual for the DIP
switch setting.
Paper Roll Shaft Hold
Sensor Block
Sensor Position Adjust
Support Roller
Thumb Wheel
Bobbin
Near-end sensor block above the bobbin
