Page 9
refer to the picture at right for one side of the paper roll compartment that there
are a plastic thumb wheel for bobbin size adjustment and a sensor block in the
wall. Turn the thumb wheel to adjust the proper position of sensor block. For
desktop application, the sensor block should be above the bobbin seating on
the 2 support rollers on bottom of paper compartment when paper near end.
For wall mount application, the sensor block should be under the bobbin
supported through a shaft held on paper compartment wall. The acceptable
paper roll bobbin outer diameter is between 18 and 24 mm.
Paper roll placement
When the paper roll to put (back)
in is already nearly used up, the
paper roll must be placed
without tilt so as not to obstruct
either paper near end sense or
paper feed action. It is also
noticed
that
some
market
available
paper
roll
has
extremely light bobbin, easily causing the paper roll to go off position when
paper feeding with low remaining paper. In this case, the paper near end sensor
may function abnormally and it would be a good solution to set in the setup
window to have the printer to send busy only when input buffer is full and not
based on every off line signal.
Paper Feed
PP-5200E can set up automatic paper feed by DIP switch, this printer default
automatic paper feed 12.5 mm before cutting.
Wall Mount
In wall mount application, the option kit will include screws plastic cotters and
a paper roll shaft. Screws and cotters are to be inserted to holes drilled on wall
and the paper roll shaft should go through the paper roll and seat in hold on
paper roll compartment wall. The paper near end sensor must be readjusted for
wall mount application as it approaches the paper roll from different direction
for desktop application.
INSTALLING DRIVER
There will be a Posiflex Product Information CD or DVD or a separate CD of
similar nature, which is specifically create for the Aura-5200E. Please find the
appropriate subfolder from the non-specific Posiflex Product Information CD
or DVD and please find the information document such as “read me” or
installation guide or application guide and follow the instructions inside.
Bobbin I.D.
Bobbin O.D.
Thermal
Paper
Surface
