Page 19
The factory default for each position listed as below:
Switch 2 Position
1
2
3
4
5
6
7
8
Default setup for Aura-
5200E
OFF OFF OFF OFF OFF OFF OFF OFF
SW3 software switch works as following:
Switch
position
ON
OFF
1
Enable “Beep” sounds after printing
Disable “Beep” sounds after printing.
2~3
Barcode Height Reduction.
4~5
Line Space Reduction
6~7
Line Feed Reduction
SW3-1 switch controlled the “Beep” sound after printing. Please select “ON”
if this beep sound is required and it will not make any sound after “OFF” is
selected.
Software switch SW3-2 & 3 is helping user to saving paper by reduce the
barcode height to 25%, 50% or 75% of the original size. Please refer to the
following table to change this switch’s setting.
Effect of positions 2 & 3 on Barcode Height Reduction as in table below:
SW3 Pos. 2
OFF
ON
OFF
ON
SW3 Pos. 3
OFF
OFF
ON
ON
Barcode Height
Reduce
Disable
Reduce 25%
Reduce 50%
Reduce 75%
This function is to reducing the spaces between every two lines in every single
paragraph. For SW3-4 & 5, please refer to the below table before regulate the
percentage of line space reduce.
Effect of positions 4 & 5 on Line Space Reduction as in table below:
SW3 Pos. 4
OFF
ON
OFF
ON
SW3 Pos. 5
OFF
OFF
ON
ON
Line Space Reduce
Disable
Reduce 25%
Reduce 50%
Reduce 75%
For switch 3 position 6 & 7, it can reduce the spare space between paragraphs.
No matter how many blank lines, this function will reduce the total unused
space for three particular percentages which are 25%, 50% and 75%. Please
refer to the following table to adjust switch 3-6 & 7.
Effect of positions 6 & 7 on Line Feed Reduction as in table below:
SW4 Pos. 6
OFF
ON
OFF
ON
SW4 Pos. 7
OFF
OFF
ON
ON
Line Space Reduce
Disable
Reduce 25%
Reduce 50%
Reduce 75%
