Page 18
SW2 software switch works as following:
Switch
position
ON
OFF
1
Raster Bitmap Print by line print
Raster Bitmap Print by buffer batch.
2
Disable Auto-Cutter
Enable Auto-Cutter
3
Disable paper auto-cut at top cover
close.
Enable paper auto-cut at top cover
close.
4
Printing Speed 180 mm / sec. max.
Printing Speed 220 mm / sec. max.
5
Reserved
6~8
Print Density Adjust
For switch position 2-1, it defines the printing behavior of the printer on
graphic printing. When it is set to ON, the printer prints on each printing
command received immediately. However, the printer may have to engage
brake frequently waiting for next command resulting in trembling. When this
switch is set to OFF, the printer starts printing only when more graphical data
are collected thus performing a much smoother printing operation.
Switch position 2-2, it is defines Enable Auto- Cutter, when it is set to ON and
Disable Auto-Cutter, when it is set to OFF.
Switch position 2-3, it is recommended to place at OFF. In this way, the printer
performs an automatic paper cut each time when the top hood is closed (e.g.
after paper roll loaded) with the printer in operating condition. However, if it
placing in ON and the manual cutter can be engage whenever necessary.
Switch position 2-4, it is defined Printing Speed, when it is set to ON the
printing speed is 180 mm / sec. max, when it is set to OFF the printing speed
is 220 mm / sec. max. (For better print quality, please set the printing speed at
180 mm / sec. max)
Effect of positions 6, 7 & 8 on Print Density is defined as below:
SW2 Pos.6
OFF ON
OFF ON
OFF ON
OFF ON
SW2 Pos.7
OFF OFF ON
ON
OFF OFF ON
ON
SW2 Pos.8
OFF OFF OFF OFF ON
ON
ON
ON
Print
Density
100% 110% 115% 120% 125% 130% 95% 90%
Since the qualities of different paper are not alike, please regulate the print
density to obtain the satisfaction of printing quality.
