TO RAISE UNIT TO PLAYING POSITION
1. Roll backstop into the docking trays
while the unit is in the folded and locked position
; place docking tray pins into
docking trays and through base frame thus anchoring unit to the court floor.
2. Pivot the front of the unit until the locator pins drop into place; ensure they are fully seated into the floor.
3. Loosen (turn counterclockwise) the pressure lock handwheel on the telescoping height adjustment brace.
4. Remove the padlock and through-pin in the telescoping height adjustment brace tube.
5.
Clear floor area around the unit from spectators
.
Stand to one side
of the unit and carefully and slowly lift upward
on handle located near rear of unit.
6.
Slowly
raise unit to desired height setting (8', 9' or 10').
7.
Replace through-pin and padlock
; tighten handwheel in telescoping brace securely.
TO LOWER UNIT FOR STORAGE
1. Remove docking tray pins.
2. Loosen the pressure lock handwheel on the telescoping height adjustment brace.
3. Remove the padlock and pin from telescoping brace while grasping the side handle on the rear vertical support.
4. Stand to one side and
slowly
lower the unit to the storage position.
5.
Replace through pin and padlock in telescoping brace
.
6. Tighten handwheel on telescoping brace.
7. Roll unit to storage location.
Note: Docking trays can be removed from floor when not in-use. If docking trays were removed, replace docking
trays before moving portables into position before next use.
OPERATING PROCEDURES FOR No. 1835080 and 1835108 PORTABLE BACKSTOPS
www.porterathletic.com
Copyright
2017 by Porter Athletic.
All rights reserved.
888-277-7778
7/23/2018
INST1835
Page 17 of 39
1835 Portable Basketball Backstop
Installation, Operation, and Maitenance Manual
Operating Procedures
