DETAIL "J"
7
6
*Note: Multiple components not shown for clarity.
17. With the unit securely pinned into the docking trays, raise the unit into the upright playing position. Make sure
the backboard and goal are level, the goal is 10ft above the court floor, and the goal is properly located in regards
to the court lines. Insert the locator pins (#6) into bushings attached to the auto-lift foot pad mounting plates as
shown in Detail "I" above. Mark the court floor where the taper pins of the locator pins rest on the court floor.
Remove the locator pins, lower the backstop, and roll it clear from the markings. Using an 11/16" drill bit, drill holes
straight down into the court floor to a minimum depth of 1-1/2". Using a 10mm allen key, screw in the wood inserts
provided with the locator pins. Reposition the goal into the docking trays and pin them, raise the backstop into the
upright playing position, and replace the locator pins. Pivot the front of the base until the locator pins drop into the
wood inserts. Lastly, install the locator pin cables(#7) by threading the cable eye bolt into the top of the locator pin.
Route the cable as shown in Detail "J" to easily raise and lower the locator pin by pulling the cable. Once the
padding is installed, the unit is now ready for competition.
www.porterathletic.com
Copyright
2017 by Porter Athletic.
All rights reserved.
888-277-7778
7/23/2018
INST1835
Page 14 of 39
1835 Portable Basketball Backstop
Installation, Operation, and Maitenance Manual
Assembly & Setup
