Operating Instructions
WARNING
:
Shock hazard.
Under
no circumstances should this product be
used near water.
WARNING
:
Risk of lacerations or
burns.
Do not touch work piece or
accessory immediately after operating the
tool. They can become very hot. Handle
carefully. Always allow accessories and
work piece to cool before handling.
Installing and Removing the
Battery Pack From the Tool
WARNING
:
To reduce the risk of
serious personal injury, turn tool off and
remove the battery pack before making
any adjustments or removing/installing
attachments or accessories.
An accidental
start-up can cause injury.
CAUTION:
Make certain the lock-off
button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK:
Insert
battery pack (4) firmly into tool until an
audible click is heard as shown in
Figure
B
. Ensure battery pack is fully seated and
fully latched into position.
TO REMOVE BATTERY PACK:
Depress
the battery release button (5) as shown in
Figure C
and pull battery pack out of tool.
Variable Speed Trigger Switch
The tool is turned ON and OFF by
squeezing and releasing the trigger switch
(1). The farther the trigger is depressed,
the higher the speed of the tool.
• To turn the tool on, squeeze the trigger
switch (1).
• To turn the tool off, release the trigger
switch. Your tool is equipped with a
brake. The tool will stop as soon as the
trigger switch is fully released.
NOTE:
Continuous use in variable
speed range is not recommended. It
may damage the switch and should be
avoided.
Forward/Reverse Button
A forward/reverse control button (2)
determines the rotational direction of the
tool and also serves as a lock off button.
• To select forward rotation, release the
trigger switch and depress the forward/
reverse control button on the right side
of the tool.
• To select reverse, depress the forward/
reverse control button on the left side of
the tool.
• The center position of the control button
locks the tool in the off position. When
changing the position of the control
button, be sure the trigger is released.
Attaching Accessories
WARNING
:
To reduce the risk of
serious personal injury, turn tool off and
remove the battery pack before making
any adjustments or removing/installing
attachments or accessories.
An accidental
start-up can cause injury.
CAUTION:
Use only impact
sockets. Non-impact sockets may break
and cause a hazardous condition. Inspect
socket prior to use to ensure that it
contains no cracks.
To install an accessory
, firmly push
accessory onto the 1/2” hog ring anvil
(3) as shown in
figure D
. The hog ring
(3) compresses to allow the accessory to
slide on. After the accessory is installed,
the hog ring applies pressure to help
provide accessory retention.
8
C
B
D
