INSTALLATION
GUIDE
MOUNT
THE OPERATOR(S)
§
Operator is non-handed – same operator for all hands of doors
§
Handing is determined by how the operator is mounted inside the header
§
The operator is mounted to a short aluminum “drive” plate that is held into the header by 5 mounting screws. Four (4) of the
screws secure the drive plate. One (1) screw is used to locate the drive plate using a ‘keyhole’ configuration. The keyhole allows
for easy removal of the drive plate without the need to loosen the screw. Removing the four (4) screws allows the drive plate &
operator to be removed from the header and rotated 180 degrees to change from a push to a pull or vice versa.
Drive Plate mounted in standard position using four (4) screws to secure.
Loosen the screws using a 5 mm allen wrench and slide each one off the drive plate.
1
Drive plate removed by shifting to the left and lifting the drive plate off the locating screw.
2
WWW.PORTALP.COM
|
14
Automatic Doors & Building Access Control
SW10
(Full Power) & S
W19
(Low Energy)