Porsche Cayenne 2009, Руководство пользователя

Страница: 244 / 378

244
Parking
5. Keep both buttons depressed until light-
emitting diode B starts to flash (first slowly and
then quickly).
Only release both buttons when light-emitting
diode B flashes quickly.
The rapidly flashing light-emitting diode B
confirms that the new signal has been
programmed successfully.
6. Repeat steps 3 to 5 to assign signals to the
other buttons.
Assigning garage door opener signal to
key with changeable code system
1. Please follow the operating instructions for the
original hand-held transmitter.
2. The standard codes set at the factory must be
deleted before programming for the first time.
3. Point the original transmitter at the marked
position.
4. Press the button of the original hand-held trans-
mitter and the button to be allocated on the
keypad simultaneously.
5. Keep both buttons depressed until light-
emitting diode
B
starts to flash (first slowly and
then quickly).
Only release both buttons when light-emitting
diode B flashes quickly.
The rapidly flashing light-emitting diode B
confirms that the new signal has been
programmed successfully.
6. To synchronise the system:
Press the programming button on the receiver
for the garage door drive.
Afterwards, you usually have approx.
30 seconds to initiate step 7.
7. Press the button to be assigned on the keypad
twice (for some devices you must press the
key on the keypad a third time to complete the
setting process).
8. Repeat steps 3 to 7 to assign signals to the
other buttons.
Notes
f Please consult your authorized Porsche dealer
if you have not been able to successfully as-
sign signals to the buttons even though you
have carefully followed the instructions in this
chapter and the operating instructions for the
original hand-held transmitter. Your authorized
Porsche dealer has a list of all garage door
opener signals that can be taught.
f Make sure that the battery in the hand-held
transmitter of the garage door opener is new.
If the battery voltage is inadequate, faults may
occur in the signal transfer. The HomeLink
system will then learn a faulty code, which
cannot be recognized reliably by the garage
door actuator.
Reprogramming an individual button of
keypad A
1. Press the button of keypad A to be repro-
gramed. Do not release the buttons before
step 4 is executed.
2. When the light-emitting diode B flashes slowly
(after approximately 20 seconds), point the
original transmitter at the position marked.
3. Press the button of the original hand-held
transmitter and keep it depressed.
4. The light-emitting diode B first flashes slowly
and then more quickly.
Only release both buttons when light-emitting
diode B flashes quickly.
Operating the garage door opener
f
Press the corresponding button on keypad
A
.
Light-emitting diode B lights up during signal
transfer.