![Porsche 928 GT1991 Скачать руководство пользователя страница 94](http://html1.mh-extra.com/html/porsche/928-gt1991/928-gt1991_owners-manual_1580160094.webp)
crosswise. When tightened crosswise, the
nuts will center the wheel correctly. Make
sure that the coloured wheel bolt is closest
to the valve. Screw the lockable wheel nut
onto this bolt.
6. Inflate the collapsible spare tire with the
air compressor. Check pressure with tire
pressure gauge.
7. To lower the car, turn the jack handle
counterclockwise till tire touches ground.
8. Fully lower the vehicle and remove jack.
9. Firmly tighten the wheel nuts again in a
crosswise pattern.
Lifting vehicle
Lifting with car jack
The jack ports are located below the front
and the rear of the doors underneath the
floor pan, hidden from view.
always use safety stands specifically
designed for this purpose.
• Jacking at any other place may damage
the vehicle or may result in personal in
juries.
The vehicle should never be lifted or
jacked up from underneath the engine oil
pan, the transmission housing, or the
front or rear axle. This could lead to seri-
ous damage.
Lifting with workshop hoist or floor jack
Make sure there is sufficient clearance bet-
ween pads and vehicle before driving vehicle
onto hoist, especially if the vehicle has a
large front panel or spoiler. The vehicle
must be lifted only at the lift points for the
car jack.
Take care to avoid damaging critical com-
ponents which are close to the lift points.
Correct tightness of the wheel nuts is impor-
tant. Correctly tightened nuts should have a
torque of 94 ft. lb. (130 Nm). This torque can
be obtained with the wheel nut wrench by
any person of average strength. If in doubt
about the correct tightness of wheel nuts,
have it checked with a torque wrench by your
dealer or at a service station.
WARNING
• Follow all warnings and instructions
found in this manual for changing a tire.
• The car jack must never be used as a
support to work underneath the vehicle.
If the jack is accidentally dislodged, you
or bystanders could be seriously in-
jured. When working under the vehicle
WARNING
When removing components such as en-
gine block, transmission housing, fuel
tank, wheels, front or rear axle, anchor veh-
icle to hoist or add corresponding weights
to maintain the center of gravity. Otherwise
the vehicle might tilt or slip off the hoist,
causing serious damage or personal injury.
93
Содержание 928 GT1991
