www.poolpak.com | 800-959-7725
64
| ComPak
®
Series - Installation, Operation and Maintenance
• Verify all electrical connections with the field wiring diagram. Check all connections to be sure they are tight.
• Check to be sure that all packaging materials have been removed from the unit.
• Make sure that the fan belt(s) are tight and the fan scroll turns freely in the blower housing.
• Ensure that the cold surface temperature sensor has been properly installed.
• Ensure that the pool water temperature sensor (AW units) has been properly installed.
• Complete Section 1 on the ComPak® Warranty Registration and Start-up log .
Start-Up
Follow the
Startup procedure
attached to the back of this manual, fill out all applicable fields and then send copy
to PoolPak service department.
PoolPak LLC
Attn: Service Department
P.O. Box 3331 York PA 17402.
Or fax to (717) 718-4245. Or scan and email to [email protected]
LOW VOLTAGE - DO NOT be misled by the term “low voltage.” Voltages as low as 50 volts may cause death
HIGH VOLTAGE is used in the operation of this equipment. DEATH OR SERIOUS INJURY may result
if personnel fail to observe precautions. Work on electronic equipment should not be undertaken
unless the individual(s) has (have) been trained in the proper maintenance of the equipment and is
(are) familiar with its potential hazards. Shut off power supply to equipment before beginning work
and follow lockout procedures. When working inside equipment with power off, take special care to
discharge every capacitor likely to hold dangerous potential. Be careful to not contact high voltage
connections when installing or operating this equipment.
NOTE
!
WARNING!
All warranty rights are jeopardized if the Warranty Registration & Start-Up Report
is not received within 10 days of start-up date.
NOTE
