POLYPRINT SA – TEXJET OPERATION MANUAL V6.4 EN
- 28 -
3.7.
Transporting the printer
Packaging the printer for transportation
Please make sure you have performed the following procedures before
transporting the printer.
1. Clean all the ink cartridges and place distilled water mixed with the inks
cleaner.
2. By pulling with a syringe on the tubes, clean all of them until they are
transparent. At least 150ml of liquid has to run through the white tubes to
get them transparent.
3. Perform 2 powerful cleanings until dampers and Printhead are clean too.
4. Switch of the printer and remove the power gable and the data cable.
5. Remove the cartridges and place them in a plastic bag.
6. Empty the Maintenance Tank and put it back empty to the printer.
7. Make a daily and weekly maintenance on the printer.
8. Place the transport brake for the plate and for the Printhead.
9. Repack the printer in the box it was shipped in. If you are returning the
printer for repair you do not need to include the inks or any of the
accessories including the USB cable, printer drivers or RIP software. You
should include the power cord.
10. Try to keep the printer level while transporting it.
11. Remember that when using any common carrier, the printer is their and
your responsibility until it is received in good condition at our facility. Make
certain to insure the printer for the full value.
Caution:
Don’t forget to empty the Maintenance tank (waste tank) of the
printer, or you may damage the printer.
Moving the printer to another position
Please make sure you have performed the following procedures before
moving the printer.
1. Switch of the printer and remove the power gable and the data cable.
2. Empty the Maintenance Tank and put it back empty to the printer.
3. Place the transport brake for the plate
o
Place this product on a flat, stable surface that extends around the
product. The surface should be at least 85x155cm.
o
This product will not operate properly if it is tilted or at an angle.
o
The printer must only be used indoor
o
Avoid places subject to rapid changes in temperature and humidity.
Also keep this product away from direct sunlight, strong light, or heat
sources.
o
Avoid places subject to shocks and vibrations.
