POLYPRINT SA – TEXJET OPERATION MANUAL V6.4 EN
- 16 -
Start-up and ink loading
•
Start up: The startup procedure will take about 1 Minute.
•
NON GENUINE: When you get the message, non genuine cartridge:
1. Press the DOWN button 5 times, and the display will show “Yes No”.
2. Press the LEFT button 1 time to choose “Yes”, and it will show “damage
from”.
3. Press the “DOWN” button 5 times, and it will show “Acpt. Decline.
4. Press the LEFT button 1 time to choose “Accept”. “Please wait” will
appear.
5. After 1 minute the message “READY” will appear to the display.
•
Wait for ready: Wait until the message in the display shows “Ready”.
The ON LED (16) will stop flashing and remain on.
•
Power cleaning: On the Epson panel, press the Menu button (15) and
by moving
↑
(13) or
↓
(14) go to “Maintenance”. Press button 15 to
enter the maintenance mode and go to “Powerful cleaning”. Press button
15 to enter and perform the “Powerful cleaning”. Follow the instructions
on the Epson display, by moving the ink levers (8) up and down when
requested. You need to perform the power cleaning 2 times in total.
Note: While working with refillable cartridges, keep the air inlet open, by
removing the small plastic filters from the cartridges. Never block the air
inlet when the printer is operating
Nozzle Check on paper or transparent polyester
•
After the Powerful Cleaning is performed, move the plate to the front
position by pressing button (25) and place a piece of paper on the plate.
