User Manual - PolyGard
®
CO SPC-1110
Page
22
PolyGard
is a registered trademark of MSR
SPC1110I01
Phone (858) 578-7887 & (888) GO IN
TEC
Fax (858) 578-4633 & (888) FX IN
TEC
Specification subject to change without notice.
IN
TEC
Controls, Inc., P.O. Box 12506, La Jolla, CA 92039
www.inteccontrols.com
Printed in USA 040401
11 Notes and General Information
It is important to read this user manual thoroughly and clearly understand the information and instructions. The
PolyGard
®
single point controller must be used within product specification capabilities. The appropriate operating
and maintenance instructions and recommendations must be followed.
Due to ongoing product development, MSR reserves the right to change specifications without notice. The
information contained herein is based upon data considered to be accurate. However, no guarantee is expressed
or implied regarding the accuracy of this data.
11.1 Intended product application
The PolyGard
®
CO SPC-1110 single point controller is designed and manufactured for control applications for
energy savings and OSHA air quality compliance in commercial buildings and manufacturing plants (i.e.,
detection and automatic exhaust fan control for automotive maintenance facilities, enclosed parking garages,
engine repair shops, warehouses with forklifts, fire stations, tunnels, etc.).
11.2 Installers’ responsibilities
It is the installer`s responsibility to ensure that all PolyGard
®
single point controller is installed in compliance with
all national and local codes and OSHA requirements. Installation should be implemented only by individuals
familiar with proper installation techniques and with codes, standards and proper safety procedures for control
installations and the latest edition of the National Electrical Code (ANSI/NFPA70). It is also essential to strictly
follow all instructions as provided in the user manual.
11.3 Maintenance
It is recommended that the PolyGard
®
single point controller performance check be done on a routine
schedule. Any performance deviations may be serviced based on needed requirements. Re-calibration and
part replacement may be implemented in the field by a qualified individual and with the appropriate tools.
Alternatively, the easily removable plug-in transmitter card with the sensor may be returned for service to
IN
TEC
Controls.
11.4 Limited warranty
MSR and IN
TEC
Controls warrant the PolyGard
®
single point controller for a period of two (2) years from the
date of shipment against defects in material or workmanship. Should any evidence of defects in material or
workmanship occur during the warranty period, MSR or IN
TEC
Controls will repair or replace the product at
their own discretion, without charge.
This warranty does not apply to units that have been altered, had repair attempted, or been subjected to
abuse, accidental or otherwise. The warranty also does not apply to units in which the sensor element has
been overexposed or gas poisoned. The above warranty is in lieu of all other express warranties, obligations or
liabilities.
This warranty extends only to the PolyGard
®
single point controller. MSR and IN
TEC
Controls shall not be
liable for any incidental or consequential damages arising out of or related to the use of the PolyGard
®
single
point controller.
11.5 Return instructions
If the PolyGard
®
single point controller needs to be returned to IN
TEC
Controls for service, an RMA number
must be obtained prior to sending.
