User Manual - PolyGard
®
CO SPC-1110
Page
11
PolyGard
is a registered trademark of MSR
SPC1110I01
Phone (858) 578-7887 & (888) GO IN
TEC
Fax (858) 578-4633 & (888) FX IN
TEC
Specification subject to change without notice.
IN
TEC
Controls, Inc., P.O. Box 12506, La Jolla, CA 92039
www.inteccontrols.com
Printed in USA 040401
5.5 Motherboard jumper selection table
Function
Element
Factory
Set
1-5 VDC signal for external use
X
1-5 VDC not used
X
Jumper JP1
Relay R3 will be active with low alarm
X*
1
Jumper
JP3
Relay R3 will be active with high alarm
X*
1
Jumper
JP4
Relay R3 will be not active
X*
1
Jumper
JP5
System failure also activates high alarm
X
System failure does not activate high alarm
X
Jumper JP9
High alarm without latch function
1-2
High alarm with latch function
2-3
Jumper JP12
With optional digital display
X
Without optional digital display
X
Jumper JP2
Switching differential of low trip/setpoint, 4%
1-2
Switching differential of low trip/setpoint, 10%
2-3
Jumper JP6
Switching differential of high trip/setpoint, 4%
1-2
Switching differential of high trip/setpoint, 10%
2-3
Jumper JP8
Internal function
X
Jumper JP7*
2
Internal function
2-3
Jumper JP10*
2
Internal function
1-2
Jumper JP11*
2
Note:
*
1
Only one of the three jumpers can be installed.
*
2
Do not change the factory jumper position setting.
5.6 Displayboard jumper selection table
Function
Element
Factory
Set
Display value without sign +/-
X
Jumper JP1.1
Display value with sign +/-
X
Jumper JP1.2
Button “Reset 2 (high) alarm” enabled
X
Button “Reset 2 (high) alarm” disabled
X
Jumper JP12
Internal function
X
Jumper JP7
1
1
Do not change the factory jumper position setting
