Administrator’s Guide for the V500 System
7 - 4
Network Tools
Diagnostic Tool
In the system’s user interface
In the V500 web interface
Enable Basic Mode
Enables a limited operating mode
that uses H.261 for video and G.711
for audio. This mode provides
administrators with a work-around
for interoperability issues that
cannot be solved using other
methods. The Basic Mode setting
stays in effect until you change it.
Go to
System > Admin Settings >
Network > Call Preference
and
select
Enable Basic Mode.
1.
Select
Admin Settings >
Network > Call Preference >
Call Preference.
2.
Select
Enable Basic Mode.
Near End Loop
test
Tests the system’s audio and video
circuitry, camera and monitor.
The monitor displays the video and
plays the audio that would be sent
to the far site in a call.
This test is not available when you
are in a call.
1.
On the
Diagnostics
screen,
select
Network
.
2.
Select
Near End Loop
to start
the test.
3.
Press any button on the remote
control to stop the test.
1.
Select
Diagnostics > Network
>
Near End Loop
.
2.
Click
Near End Loop
to start
the test.
3.
Click
Near End Loop
again to
end the test.
PING
test
Tests whether the system can
establish contact with a far-site IP
address that you specify.
1.
On the
Diagnostics
screen,
select
Network
>
PING
.
2.
Enter the IP address that you
wish to test.
3.
Select
Start
.
If the test is successful, the
V500 system displays a
message indicating that the IP
address under test is available.
1.
Select
Diagnostics > Network
> PING
.
2.
Enter the IP address that you
wish to test.
3.
Click the
PING
icon.
If the test is successful, the
V500 system displays a
message indicating that the IP
address under test is available.
Trace Route
test
Tests the routing path between the
local system and the IP address
entered.
1.
On the
Diagnostics
screen,
select
Network > Trace Route
.
2.
Enter the IP address that you
wish to trace.
3.
Select
Start
.
If the test is successful, the
V500 system lists the hops
between the system and the IP
address you entered.
1.
Select
Diagnostics > Network
> Trace Route
.
2.
Enter the IP address that you
wish to test.
3.
Click
Trace Route
.
If the test is successful, the
V500 system lists the hops
between the system and the IP
address you entered.
Содержание V500
