13
9.
Enter the AC code you created earlier in
Configuring the DECT System on the KWS600v3 on
page 9
and press the check mark (
).
NOTE:
The handset should now be registered, and should display the assigned identity. If it does not
register, wait 10 seconds and then repeat the steps above.
Manually Registering the 5020/5040 Handsets
1.
Insert the battery, plug in the charger, and place the handset in the charger for four hours.
2.
Press the left softkey to turn on the handset.
3.
Press
Menu
to enter the main menu.
4.
Scroll to
Settings
and press
Select
.
5.
Scroll to
Advanced
and press
Select
.
6.
Scroll to
Login
and press
Select
.
7.
Scroll to
Create login
and press
Select
. The handset will begin searching for a system.
8.
Scroll to the found system and press
Select
.
9.
Enter the AC code you created in
Configuring the DECT System on the KWS600v3 on page 9
and
press
OK
to connect to the system.
10.
Press
OK
.
NOTE:
The handset should now be registered, and should display the assigned identity. If it does not
register, wait 10 seconds and then repeat the steps above.
Programming the Repeaters Using the KIRK
Programming Kit Repeater
NOTE:
To program the repeater, you need the programming software (ServiceTool), and the power
supply. The ServiceTool is not part of the Programming Kit Repeater, but can be downloaded from
www.polycom.com
. The power supply for the repeater is to be ordered separately (UK version part
number: 84642421; EU version part number: 84642420; US version part number: 84642432).
Setting Up the Hardware for Programming the Repeater
1.
Unplug the repeater power supply and insert the splitter. Connect the repeater power supply to the
splitter and the mains.
NOTE:
Ensure that you have the appropriate power supply for the local requirements.
2.
Connect the serial cable to the splitter and com port of your computer. The repeater is now ready
for programming via the ServiceTool.
NOTE:
The above mentioned order of the setup (Steps 1 and 2) is important.
