6
Configuration
This section provides instructions on how to configure the UC server and the KWS600v3 and its
associated DECT handsets so that the UC server user identities are associated with the handsets.
The configuration process consists of several steps:
1.
Create a UC server user identity for each user that will be assigned a DECT handset. For
information on how to create user identities, refer to the
NetVanta Unified Communications
Server Administrator Manual
, available at
http://kb.adtran.com
, or the installation media.
2.
Gather the information that you will need to configure each DECT handset.
3.
Configure the KWS600v3 to communicate with the UC server.
4.
Configure the KWS600v3 to communicate with the DECT handsets and associate each handset
with the appropriate UC server user identity.
5.
Test your configuration.
Gathering Information
To configure the device, you need the following information.
Identity/Name:
This is the identity address (extension) that you want to associate with the
device.
Authentication User ID:
This is the Session Initiation Protocol (SIP) authentication user name
associated with the above identity. This is required by any SIP endpoint to
register with the SIP PBX.
Authentication Password:
This is the SIP authentication password associated with the above identity.
IPEI:
This is the 12-digit serial number of the handset.
Determining the Authentication ID and Password as the User (that owns the
identity)
1.
Start the UC client.
2.
Log in as the user whose identity you want to associate with the handset.
3.
In the bottom left pane, take note of the identity name and address.
