POLTI unico MCV80 total clean & turbo, Инструкция по эксплуатации

Страница: 43 / 139

approximately twice per year.
Should the appliance be used frequently for
vacuuming liquid dirt, repeat the operation
more frequently.
19. CLEANING THE BOILER
(extraordinary maintenance)
Use Allen key no. 6.
To maintain maximum performance, clean
the boiler once per year and/or every 50
intense uses.
19.1 Fully empty the tank and remove the dirt
collector.
19.2 Put the appliance on its side and remove
the lid using a coin (41).
19.3 Unscrew the boiler cap using Allen key
no. 6 (42).
19.4 Pour 200 ml of tap water into the boiler.
19.5 Rinse the boiler and pour the water into
the sink or into a special container for dirty
water. If the water is very dirty, repeat the
operation until the water is clean (43).
19.6 Insert 200 ml of water in the boiler and
screw on the cap, ensuring the seal is present
and that it is correctly screwed on. Replace
the lid.
19.7 Fill the water tank again and close the
door.
19.8 Turn the appliance back on.
Before using steam to clean, direct the jet
into a sink or other container until the steam
is completely clean.
20. CLEANING THE MINI TURBO
BRUSH
(extraordinary maintenance)
20.1
Rotate the locknut and remove the upper
part of the mini turbo brush.
20.2 Clean the inside of the brush and re-
close following the procedure in reverse
order.
21. CLEANING THE FLOOR TURBO
BRUSH
(extraordinary maintenance)
21.1 Remove the door and clean the inside of
the brush.
21.2 Close the brush following the procedure
in reverse order.
22. CLEANING THE VACUUM
TUBES
(extraordinary maintenance)
22.1 Switch on the appliance by pressing the
power switch.
22.2 Vacuum 0.5l of clean water from a
container (44) and empty the dirt collector.
22.3 Repeat the operation until the water in
the dirt collector is sufficiently clean.
22.4 With the dirt collector clean and dry,
vacuum air for at least 5 minutes to
completely dry the tubes.
22.5 Ensure that the dirt collector and filters
are completely dry.
22.6 Make sure that the tubes are not
clogged using the cleaning brush:
1 - Cleaning the handle-side tube: insert the
cleaning brush to the end of the handle
making sure that there are not blockages
and/or foreign bodies which could block
suction.
2 - Cleaning the tube between collector and
hose adapter: insert the cleaning brush into
the tube making sure that there are no
blockages and/or foreign bodies which could
block the suction flow. Perform the operation
also on the side of the HEPA filter.
3 - Cleaning the tube between collector and
WARNING: Steam.
Risk of scalding!
WARNING: Risk of scalding! When accessing
the boiler (removing the cap, filling up,
emptying), ensure that the appliance is swit-
ched off at the power switch and disconnec-
ted from the mains for at least two hours.
WARNING: Do not exceed the quantity of
water indicated and pour it slowly into the
boiler, making sure not to let it overflow.
1 2 3
E
N
G
L
IS
H
| 43 |