POLTI unico MCV80 total clean & turbo, Инструкция по эксплуатации

Страница: 46 / 139

Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com
for the up-to-date list) or Customer Services.
PROBLEM CAUSE SOLUTION
The appliance is pressurised but re-
leases little steam.
The steam is set to the mini-
mum level.
Press the steam adjustment button
(+) to increase the steam being di-
spensed.
There is a bad smell when turning on
suction.
Dirt collector is dirty or too
wet.
Clean the dirt collector as described in
Chapter 13 or simply dry it out If the
smell persists, carry out a full clean as
described in Chapters 13, 14, and 17.
Steam is dispensed mixed with dro-
ps of water.
The steam hose and/or the te-
lescopic tube are cold.
Direct the steam jet onto a cloth to
heat up the tubes.
The holder with cloth for steam clea-
ning does not lock onto the brush.
The brush is in position B or C. Set the universal brush to position A.
Accessories are difficult to assem-
ble.
The seals produce friction. Lubricate the gasket with silicone
grease or Vaseline, or alternatively
with a small amount of vegetable oil.
Steam or condensation leaks out
between the handle and the telesco-
pic tube.
Seals worn, cut or missing. Replace the seals, as indicated in
Chapter 24.
The filling pump of the boiler conti-
nues to operate.
There is air in the boiler circuit. Turn off the appliance and leave it to
cool, then repeat the operations de-
scribed in Chapter 1.
After vacuuming, traces of liquid re-
main on the flooring.
Liquid remains inside the tu-
bes.
Floor not yet dry
Suck in air for a few seconds to allow
the transfer of the liquid to the tank.
Repeat the vacuuming.
ALARMS CAUSE SOLUTION
Boiler fault. Turn the appliance off for a few
minutes and then start it again.
Should the problem occur again,
contact an Authorised Service
Centre.
The boiler
does not
reach the
desired tem-
perature.
Turn the appliance off for a few
minutes and then start it again.
Should the problem occur again,
contact an Authorised Service
Centre.
The pump
continues to
take in wa-
ter.
Turn the appliance off for a few
minutes and then start it again.
Should the problem occur again,
contact an Authorised Service
Centre.
- “Out of water” indicator light
flashing.
- Prolonged beeping sound.
- LED programs flashing.
- 1st steam adjustment LED fla-
shing.
- “Out of water” indicator light fla-
shing.
- Prolonged beeping sound.
- LED programs flashing.
- 2nd steam adjustment LED fla-
shing.
- “Out of water” indicator light
flashing.
- Prolonged beeping sound.
- LED programs flashing.
- 3rd steam adjustment LED fla-
shing.
IT
A
L
IA
N
O
E
N
G
L
IS
H
| 46 |