39
•
Stock spare Decoration Plates in case of damage during disassembly.
•
At 3 when removing the Click Plate, use care to prevent losing the two small steel
ball bearings located in recesses on the underside of the Click Plate.
•
For 5 , 6 , & 7 :
-
Unplug connector 5 from CN4 on the Main PC Board.
-
Unplug the black wire 6 at the in-line connector.
-
Unsolder the red wire 7 from the Power ON/OFF Switch.
•
For 8 - 11 :
Remove the hex nuts from the Left and Right Holder mounting screws and lift the
Flash Assembly and Holders up off the Camera Body (mounting screws will remain in
the Holders). Slip the wiring 5 , 6 , and 7 and attached connectors through the
opening in the Body.
•
Remove the Right Holder (Hand Grip side) from the Flash Assembly.
•
If it is necessary to remove the Left Holder (Viewfinder side):
Remove the cemented Decoration Plate 12 from the left Holder; remove the Flash
Switch mounting screws 13 ; slip Switch and wiring through opening in Holder.
Содержание Miniportrait 455
