Polaroid Miniportrait 455, Руководство по ремонту

Страница: 30 / 59

30
Camera Body Disassembly and Reassembly
(Figures 3-1 through 3-3)
This procedure describes removing and replacing components and assemblies from the
front, back, bottom, and interior of the camera body. Other assemblies such as the flash
unit, viewfinder and handgrip are covered later in separate procedures.)
If all camera body components are to be removed, the removal sequence shown below
can be followed. This same sequence is shown on the accompanying drawings by the
circled numbers 1 2 3 , etc.
If only certain components or assemblies need to be removed from the camera body, this
can often be done without disturbing other body assemblies. (See Table 3-1.)
Remember that many parts of the shutter mechanism (including the drive motor) can be
serviced without removing the entire shutter mechanism from the camera. See “Shutter
Mechanism Note” earlier under General Guidelines.)
If further disassembly is required, refer to the exploded views (“Plates”) in the 455 Parts
Catalog.
Table 3-1. Removing Individual Components from Camera Body
To Remove: First remove these parts
Tripod
Holder Light Lenses Decoration Front Shafts Bottom Socket
Frame Baffle Cover Panel Cover Frame
Main PC X X
Board
Motor with X X
Motor Disk
Shutter X X X X X X
Mechanism
Sonar X X X
Sonar PC X X X X X
Board
Bottom X X X
Cover
Tripod X X X X X
Socket