57
Replacing the Shutter Assembly in the Camera
•
Insert the reassembled Shutter Assembly into the Camera Body from the front.
Secure it with four screws at the corners of the Base Plate.
Caution
Don’t let wires become pinched between Base Plate and
Camera Body! Refer to Figure 3-31 for wiring placement.
•
Reconnect wiring to the Main PC Board, X-Sync Connector, etc., as necessary (see
preceding section).
If the wires to the X-Sync Connector were pulled through the opening in the floor of the
Camera Body, the following steps may be necessary:
-
Remove the Bottom Frame, Sonar PC Board and wiring Cap (Figure 3-28).
-
Feed yellow and white wires through opening, resolder, and replace wiring Cap,
Sonar PC Board and Bottom Frame.
Note: Bottom Frame is not symmetrical: install as shown in Figure 3-29.
Figure 3-28. Replacing the shutter assembly in the camera body
Содержание Miniportrait 455
