58
Figure 3-29. Correct mounting of bottom frame
•
Install the four brass Shafts, using four screws, as shown in Figure 3-28. Be sure
Shaft seats fully into the hole on the inside of the Camera Body.
•
Replace the Light Baffle, Bottom Cover, Pack Film Holder Frame, Front Panel
Assembly, Decoration Cover, Lenses and Lens Caps (see “Camera Body
Disassembly and Reassembly” and Figure 3-1).
•
When replacing the Front Panel Assembly, refer to Figure 3-30. Start at the top and
carefully position slow “a” over the rim of the Exposure Counter wheel.
•
Next engage hole “b” in the Mode Select Slide with the pin on the Mode Select Lever.
•
Similarly, engage hole “c” with the pin on the Aperture Selector Lever, and hole “d”
with the pin on the Shutter Speed Selector Lever.
Содержание Miniportrait 455
