- 15 -
1401_GB-EINSATZ_293
GB
OPERATION
Important before starting work
1. Switch on p.t.o.
Only switch p.t.o. on when all protective fittings (covers,
protective cloths, claddings, etc.) are in good order and
are affixed to implement in the protection position.
2. Switch machine on only in the working position
and do not exceed given p.t.o. speed (eg. max.
540 U/MIN)!
A transfer, located near the transmission, advises the
p.t.o. speed that your machine is equipped for.
P.t.o. speed
- Max. p.t.o. speed = 540 U/min.
The most favourable p.t.o. speed is approx.
approx.
450 U/min.
- If tines are pulling fodder from swath back into raked
strip (messy work), then reduce the p.t.o. speed.
Hydraulic servo-valve (ST
- Move servo (ST) to "Neutral" or "Lower" position.
Safety advice
(see Supple-
ment-A1 pts. 1, 2,
3 and 4)
P.t.o. must be
switched off be-
fore carrying out
any work in the
rotor area.
General guidelines for working with the
implement.
Be advised!
Do not enter the rotor area while the drive
motor is running.
- Select a speed that ensures all harvested produce is
cleanly taken.
495.173
If overloaded, change back a gear.
- To achieve clean work, rotor should be as horizontal as
possible. A very slight incline forward is allowed.
- Tine height is set using spindle (8). Tines should lightly
touch ground. Fodder becomes dirty or turf becomes
damaged if setting is too low.
Set feeler wheel (optional)
- Tine height is set by appropriately positioning the linch
pin (V). Tines should lightly touch the ground. Fodder
becomes dirty or turf becomes damaged if the setting
is too low.
159-02-39
V
