- 18 -
GB
1400_GB-ALLG WARTUNG_BA
Hydraulic unit
Caution injury and infection hazard!
Liquids discharging at high pressure may penetrate the
skin. Therefore seek immediate medical help!
Make sure that the hydraulic system is suitable for the
tractor before connecting the hydraulic lines.
After the first 10 hours in operation and thereafter
every 50 hours in operation
- Check hydraulic unit and piping for leaks and if necessary
re-tighten bolt connections.
Prior to every taking into operation
- Check hydraulic hoses for wear.
Replace any worn or damaged hydraulic hoses
immediately. The replacement hoses must meet the
manufacturer’s technical requirements.
Hose lines are subject to natural ageing. The period of use
should not exceed 5 – 6 years.
Parking in the open
Clean and protect the piston rods with
grease prior to longer periods parked
outside.
FETT
TD 49/93/2
Cleaning of machine parts
Be advised! Do not use high-pressure washers for the
cleaning of bearing- and hydraulic parts.
- Danger of rust!
- After cleaning, lubricate the implement according to
the lubrication plan and perform a brief test run.
- Cleaning pressure
being too high
may damage
the paint.
Safety advice
• Switch off engine prior to any adjustment, maintenance
or repair work.
Winter storage
- Clean implement thoroughly prior to winter storage.
- Put up protection against weather.
- Change or top up gear oil.
- Protect exposed parts from rust.
- Lubricate all greasing points according to lubrication chart.
- Disconnect terminal, store dry and protected from frost.
Cardans
- See information in Attachment
Please observe the following for maintenance!
The instructions in these Operating Instructions apply.
If no particular instructions are available here, then the
information in the instructions supplied by the respective
cardan shaft manufacturer apply.
General maintenance information
Please observe the infiormation below to maintain the
implement in good condition even after a long period in
operation:
- Re-tighten all bolts after the first
hours in operation.
The following should be checked
in particular:
Blade bolt connections at mower
Tine bolt connections at rake and
tedder
Spare parts
a. Original parts and accessories are specially designed
for the implements.
b. We expressly point out that we have not tested or
approved any original parts and accessories not supplied
by us.
c. The installation and/or use of such products may under
certain circumstances negatively modify or impair the
propeties of the implement as specified in the design.
Any liability on the part of the manufacturer is excluded
in the event of any damage due to the use of non-original
parts and accessories.
d. Any unauthorised modifications or the use of components
and attachments at the implement rules out any liability
on the part of the manufacturer.
GENERAL MAINTENANCE
Safety advice
• Switch off engine
and remove igni-
tion key prior to
any adjustment,
maintenance or
repair work.
• Only perform
work underneath
the implement
with secure sup-
ports.
• Re-tighten all
bolts after the
first hours in
operation.
• Only park imple-
ment on flat, firm
ground.
Repair information
Please observe the
repair information
in the Attachment
(If available).
Safety advice
Clean the cou-
pling plug of the
hydraulic hoses
and the oil socket
prior to each con-
nection.
Note any abrasion
and clamping
points.
MAINTENANCE
