Plug-In Solar Sheet Metal/Flat Roof Mount Kit, Руководство по установке, Страница: 15 / 37

Plug-In Solar
289 London Road | Burgess Hill | West Sussex | RH15 9QU
www.pluginsolar.co.uk | info@pluginsolar.co.uk | 01444 672005
Page 15
1.3. Once the power is disconnected, wire the Plug-In Solar Connection Unit using the following
instructions.
Wire Identification (if in doubt consult a qualified electrician)
EARTH – Green and Yellow Sleeving
LIVE – Red or Brown
NEUTRAL – Blue or Black
a) If using the Plug-In Solar Connection Unit to replace an old socket (or similar), note the cable
connections and wire up the Plug-In Solar Connection Unit the same way as the replaced item, with
earthing as stated in these instructions.
b) Route the cable through the appropriate entry point of the mounting box (this is usually at the rear).
c) Cables should be prepared so sufficient conductor length reaches the terminals. Strip the ends of
the individual conductors so that an adequate length enters the terminals.
d) Carefully arrange the wiring to lie along the edges of the product or box, keeping the central area
clear.
e) Wire the Plug-In Solar Connection Unit using the following diagram (a larger version can be found in
Appendix 1):
f) When connecting the Plug-In Solar Connection Unit ensure that only the bare end of the wire enters
the terminal, and no bare wires are visible. Always tighten the terminal screws, but don’t over
tighten. An earth connection should always be made between the mounting box earth terminal and
the fused connection unit terminal. If the earth wire is bare, it must be sleeved with appropriate
green/yellow sleeving.
g) If you are in any doubt about connecting this product consult a qualified electrician.
1.4. Wiring insulation tests should be completed to avoid misleading instrument readings and
possible internal damage to the unit. Check your work thoroughly before restoring power to the
circuit. If you are not certain, seek professional advice.
1.5. Once power has been restored, your Plug-In Solar kit will be feeding FREE electricity into
your mains circuit.