Installation manual SR85/CF COVER FEEDER
1.
Cut the three red cable ties and remove the cardboard between the Upper paper
path and the frame. Figure 1 and Figure 2.
1.3 Remove the red cable ties
1.
Undock the Booklet maker.
2.
Remove the power cord and the communication cable from the Booklet maker.
3.
Remove the Infeed cover on the Booklet maker, according to REP 1.4 in the SR85
Service manual.
4.
Open the Top cover.
5.
Route the Power Supply Harness, PSH, make sure that the connector is on the
infeed side of the Booklet maker. Route it, between the inside of the Top cover
and the reinforcement by the right hinge, according to figure 1.
Figure 2
Figure 1
1.4 Routing the Power Supply Harness, PSH
Cable tie
Cable tie
Cable tie
Cardboard
pice
1-4
