Plextor PlexWriter 12/10/32S, Руководство по эксплуатации

Страница: 31 / 88

Section 2. Installing Your PlexWriter SCSI Drive
PlexWriter 12/10/32S Operation Manual
27
10. Connect the audio cable if you want to use a sound board in your system. This
cable runs from the four-pin audio output connector on the rear panel of your
PlexWriter drive to your sound board. See “Using Sound Boards and Audio
Cables” on page 31 for more information about audio cables.
Figure 15: Installing the Optional SPDIF Cable
11. Connect the SPDIF cable if your sound board is equipped with SPDIF and you
wish to use the SPDIF digital audio output from your PlexWriter. This cable runs
from the right-most set of pins on the jumper panel to the sound board. Figure 15
shows how the optional SPDIF cable is connected to the jumper panel. (The
SPDIF cable is not supplied by Plextor.)
12. Before completing the installation, check your cable connections against Figure
16.