Plextor PlexWriter 12/10/32S, Руководство по эксплуатации

Страница: 29 / 88

Section 2. Installing Your PlexWriter SCSI Drive
PlexWriter 12/10/32S Operation Manual
25
NOTE: Plextor does not provide rails. If you need rails, you can obtain them from the
computer manufacturer or from a computer supply retail or mail-order store. Most rail
kits are specific to a particular type of PC case. Check with the computer
manufacturer to make sure you get the correct rail kit.
5. If you must use mounting rails, fasten the rails to the lower pair of holes as
shown in Figure 13. (In some instances, you may need to fasten the rails to the
upper set of holes.) After fastening the rails, check their positioning by sliding the
drive into the bay before you mount the drive or connect any cables.
Figure 13: Installing Mounting Rails (if Needed)
6. Plug a free connector on the SCSI cable into the SCSI connector on the rear panel
of the drive before you insert the drive into your computer. Then thread the cable
through the front of the open bay you plan to use and back toward the SCSI
interface board. The drive should slide smoothly into the bay. If it does not,
check for obstructions in the bay and ensure the side rails (if needed) are attached
properly.