• IMPORTANT: Proceed with extreme caution when
cutting the liner.
• The two screws which you left in the top and bottom
of the inlet/low level suction fitting(s) need to be
located through the liner. To do this carefully feel
for them and cut a small cross hair with a knife
(remembering that the crosshairs are in North,
East, South and West positions). Do not cut the
whole width of the screw head. Gently ease the
screws through the small incision.
• Now locate the faceplate and attach gasket for the
inlet low level suction fitting.
• Using the two screw positions already exposed,
undo the top screw and attach the faceplate at the
top. The faceplate will swing down into the correct
position to line up with the bottom screw. Undo and
attach bottom screw through faceplate.
• Now fix the left and right screws (supplied with
fitting) knowing they will be in the correct position.
• Use a handheld screwdriver (not cordless) so that
you can tighten the faceplate screws without
damaging the screw holes.
• Screw on the relevant fixed grill for a low level
suction or directional eyeball for a return inlet.
• Carefully cut the fitting (below)
– 14 –
