Fitting the Linerlock
• You will be supplied with a white plastic profile
called Linerlock. This is fitted at the top of the wall
under the top shelving as shown. You can mitre the
Linerlock at each corner of the pool, but this is not
essential as you can cut a straight edge and butt
the two pieces of Linerlock together. This will not
be seen once the liner is installed.
• The important key points when fitting the Linerlock
are that you carefully line up the slots which accept
the liner and you use the stainless steel screws
provided in the fixings kit, spaced approximately
every 300mm.
• To make installation easier pre-drill the screw
positions in the Linerlock using a 3mm drill bit.
• Once you have the Linerlock fitted, use some of the
clipper tape provided to cover any sharp edges
such as knots and corners within the pool structure
to protect your liner. Mechanical damage to your
liner is not covered by your warranty.
Fitting the Felt Underlay
• Using a sharp pair of scissors cut the felt to suit the
shape of the pool floor.
• Use the clipper tape to cover any joins in felt.
– 12 –
