Fixing the Return (10ft models)
• Use the two 3.5mm x 20mm countersunk screws
provided in the fixing kit to secure the return fitting
on the inside of the pool as shown.
Fixing the Return Low Level Suction (8ft models)
• On the 8ft model there is no skimmer. Instead you
have a plank with two holes that is used for the
return and low level suction.
• Use the 3.5mm x 20mm countersunk screws
provided in the fixing kit to secure the return and
low level suction fitting on the inside of the pool.
Gaskets
•
IMPORTANT:
Do not fully insert any screws into the
pool fittings at this stage as you may strip the thread
before installing the faceplate and liner.
• Position the self adhesive gaskets carefully and
stick into place.
• With an inlet/low level suction use two screws
provided with the product.
• Partially insert a screw at the top and bottom
positions of the fitting. Ensure the cross head of the
screws finish in the North, East, South and West
position. This will help with the installation of the
liner later on.
• For the skimmer, position the self adhesive gasket
carefully into location using four screws supplied
with the product. Partially insert the screws in the
four corners of the skimmer. Ensure the cross
heads of the screws finish in the North, East, South
and West position as shown.
– 11 –
